ADICO constant temperature and humidity room meets:
GB/T2423.1 Test A: Low temperature test method
GB/T2423.2 Test B: High temperature test method
Technical conditions of GB/T11158 high temperature test chamber
Technical conditions of GB/T10589 low temperature test chamber
GB/T 2423.22 test Nb: temperature change test GB/T 2423.4 test Db: alternating damp heat test;
GB/T 31467.1 Lithium-ion power battery packs and systems for electric vehicles Part 1: Test procedures for high-power applications
GB/T 31467.2 Lithium-ion power battery packs and systems for electric vehicles Part 2: Test procedures for high-energy applications
GB/T 31467.3 Lithium-ion power battery packs and systems for electric vehicles Part 3: Safety requirements and test methods
GB/T 31484 Cycle life requirements and test methods for power batteries for electric vehicles
GB/T 31485 Safety requirements and test methods for power batteries for electric vehicles
GB/T 31486 Electric performance requirements and test methods for power batteries for electric vehicles
GB/T2423.3 Constant humidity test GJB150.3-2009 high temperature test GJB150.4-2009 low temperature test
GJB150.9 damp heat test test standard requirements GB/T5170.2-2008 temperature test equipment
GB/T5170.5 damp heat test equipment, meeting the requirements of 8.1 damp heat alternating cycle test in "Test Procedures for Lithium Ion Power Batteries for Electric Vehicles Part 2 High Energy Applications"
4600×1900×2600(Depth × width × height, unit mm)
Operating temperature range
-45℃～85℃ (heating rate≥3℃/min, cooling rate≥2℃/min) no load
Rising and cooling rate
Under the specified factory conditions:
≥3℃/min, no load, average throughout the whole process
≥2℃/min, no load, average throughout the whole process
Temperature test (no load)
Alternating damp heat test (no load)
Temperature and humidity range
Circulating wind in the box
The average wind speed complies with the requirements of GB/T 10592-2008 and can be automatically adjusted with each test item in the no-load, test-piece unloaded, and test-piece loaded state.
The electrical insulation performance of the equipment meets the relevant national standards
The compressor cabinet has a silent design, and the noise of the whole machine is ≤63dB (the measurement method is carried out according to the requirements of Article 8.5 of GB/T 5170.2-2008). If there is a soundproof room, it is the noise outside the room.
Vibration and shock
All equipment and its components should be able to withstand shock and vibration during use without damage or failure;
All equipment and its components should be able to withstand shock and vibration during transportation and installation without damage or failure.
The European intelligent expansion valve system + the American pulse refrigeration battery valve control system automatically adjusts the refrigerant flow according to the load, saves water and electricity, and adopts the latest research and development of cold-end balancing technology, that is, the equipment controller will be based on the current test conditions of the equipment. Automatic calculation and control of the energy output of the equipment's refrigeration system. Compared with the traditional cooling capacity, the heat balance method of constant temperature and humidity through thermal hedge is more energy-saving, water-saving and energy-saving. (The energy consumption value of the equipment is only 30% of the traditional equipment under high temperature and humidity conditions)